我有 2 台交换机之间的 LACP 绑定中继链路，绑定包含 4 个接口；除了一个接口外，所有接口都可以正常工作。思科说你必须在所有接口上都有匹配的配置。

暂停接口上的速度以 auto-100 运行，但是，绑定接口以 auto-1000 运行。如果我用 覆盖此值speed 1000，链接将变为not connected

开关 1

NON WORKING INTERFACE:
GigabitEthernet0/1 is up, line protocol is down (SUSPENDED)
  Hardware is Gigabit Ethernet, address is XXXX.XXXX.XXXX (bia XXX.XXXX.XXXX)
  MTU 9000 bytes, BW 100000 Kbit, DLY 100 usec,
     reliability 255/255, txload 1/255, rxload 1/255
  Encapsulation ARPA, loopback not set
  Keepalive set (10 sec)
  Full-duplex, 100Mb/s, media type is 10/100/1000BaseTX
  input flow-control is off, output flow-control is unsupported
  ARP type: ARPA, ARP Timeout 04:00:00
  Last input 1d03h, output 1d04h, output hang never

WORKING INTERFACE ON SWITCH 1:
GigabitEthernet0/2 is up, line protocol is up (connected)
  Hardware is Gigabit Ethernet, address is XXXX.XXXX.XXXX (bia XXXX.XXXX.XXXX)
  MTU 9000 bytes, BW 1000000 Kbit, DLY 10 usec,
     reliability 255/255, txload 1/255, rxload 1/255
  Encapsulation ARPA, loopback not set
  Keepalive set (10 sec)
  Full-duplex, 1000Mb/s, media type is 10/100/1000BaseTX
  input flow-control is off, output flow-control is unsupported
  ARP type: ARPA, ARP Timeout 04:00:00
  Last input 00:00:11, output 00:00:08, output hang never