网络工程 - 使能H3C S5820X-28S交换机以太网口 - 吾爱随笔录

我正在研究客户的 H3C S5820X-28S 交换机。我完全不熟悉 H3C（据我所知，它只是一个预买断的 HP 交换机），只接触了 Cisco 和一些 Juniper 交换机。

Anywho，我有一个 10Gig 端口，它似乎已配置，但由于某种原因拒绝打开。它位于远程数据中心，我看到交换机说我们已正确修补它，但没有获得链接。我已经设法调出它当前的配置，这就是它的设置：

 [conf]display interface Ten-GigabitEthernet1/0/14
 Ten-GigabitEthernet1/0/14 current state: DOWN
 IP Packet Frame Type: PKTFMT_ETHNT_2, Hardware Address: 3822-d6e5-3763
 Description: Ten-GigabitEthernet1/0/14 Interface
 Loopback is not set
 Media type is stack wire,Port hardware type is STACK_SFP_PLUS
 10Gbps-speed mode, full-duplex mode
 Link speed type is force link, link duplex type is force link
 Flow-control is not enabled
 The Maximum Frame Length is 10000
 Broadcast MAX-ratio: 100%
 Unicast MAX-ratio: 100%
 Multicast MAX-ratio: 100%
 Allow jumbo frame to pass
 PVID: 101
 Link delay is 0(sec)
 Port link-type: access
 Tagged   VLAN ID : none
 Untagged VLAN ID : 101
 Port priority: 0
 Peak value of input: 0 bytes/sec, at 2003-08-06 09:46:13
 Peak value of output: 0 bytes/sec, at 2003-08-06 09:46:13
 Last 300 seconds input:  0 packets/sec 0 bytes/sec 0%
 Last 300 seconds output:  0 packets/sec 0 bytes/sec 0%
 Input (total):  0 packets, 0 bytes
         0 unicasts, 0 broadcasts, 0 multicasts, 0 pauses
 Input (normal):  0 packets, - bytes
         0 unicasts, 0 broadcasts, 0 multicasts, 0 pauses
 Input:  0 input errors, 0 runts, 0 giants, 0 throttles
         0 CRC, 0 frame, - overruns, 0 aborts
         - ignored, - parity errors
 Output (total): 0 packets, 0 bytes
         0 unicasts, 0 broadcasts, 0 multicasts, 0 pauses
 Output (normal): 0 packets, - bytes
         0 unicasts, 0 broadcasts, 0 multicasts, 0 pauses
 Output: 0 output errors, - underruns, - buffer failures
         0 aborts, 0 deferred, 0 collisions, 0 late collisions
         0 lost carrier, - no carrier

我已经手动启用/禁用了端口，shutdown/undo shutdown但仍然无法让它工作。有什么我可能在配置中遗漏的吗？